East German AK-47 Blank Fire Adapter

NVA Blank Fire Adapter

This is a blank fire adapter issued to the East German Army, the Nationale Volksarmee (NVA), for its AK-pattern rifles. It threads onto the muzzle and restricts the bore, so the gas from a blank cartridge builds enough pressure to cycle the action. The rifle then runs semi- or full-auto on blanks instead of needing a hand-worked bolt for every shot. Reenactors, film and stage armorers, and collectors of Warsaw Pact kit use it to complete an East German AK display or training setup.

Features

• East German Army Issue — Original government-issue NVA equipment, not an aftermarket copy.
• Threaded Muzzle Mount — Screws onto the AK muzzle threads in the spot normally taken by the thread protector nut.
• Flanged Rear Collar — A raised lip at the threaded end seats against the front sight block when the adapter is tightened down.
• Knurled Grip Band — A diamond-pattern textured ring around the body gives your fingers purchase when you fit or remove it by hand.
• Slotted Muzzle End — Notches cut into the front edge sit in line with the front sight detent pin, which locks the adapter in place the same way it holds a muzzle nut.
• Restricted Bore Design — The constricted interior traps blank gas so the rifle's gas system has enough pressure to cycle.
• Silver Metal Finish — The bright body stands out clearly against a blued or black rifle, so anyone nearby can see a blank adapter is fitted.
• Stamped Marking — A small factory stamp on the body near the muzzle end identifies the part.

Issue Pattern and Fit

The NVA fielded its own licensed Kalashnikov rifles, and this adapter was part of the training kit issued alongside them. It is a straight tube with a knurled band toward the rear and a flanged, threaded collar that seats against the front sight block. On any AK-pattern rifle with compatible muzzle threads and a sight-block detent pin, it fits like a muzzle nut. It is built for blank ammunition only. Remove it before you load or fire live rounds.