Glock 19 Complete Lower Parts Kit

G19 Lower Parts Kit

This United Defense kit holds the internal frame parts a Glock 19 pattern pistol needs to function: the trigger group, controls, springs and pins. A lower parts kit, or LPK, is what you install into a bare frame to finish a build. It also works as a set of spares when you replace worn parts on a pistol you already own. It suits home builders and owners who would rather have every lower part on hand at once than order them one by one.

Features

• Flat-Face Trigger Shoe — The black trigger has a straight, flat face instead of the curved factory profile, so your finger lands in the same spot on every press.
• Trigger Bar And Housing — A bright steel trigger bar comes paired with a black trigger housing, the block that holds the connector and ejector and guides the trigger's movement.
• Slide Stop Lever — The lever that locks the slide open on an empty magazine is included, with its wire spring already attached.
• Magazine Catch And Spring — The magazine release button comes with its small wire spring, which holds the magazine in place until you press the catch.
• Slide Lock — The serrated slide lock is the part you pull down during field stripping to take the slide off the frame.
• Frame Pin Set — Several steel pins of different lengths secure the trigger housing, trigger and locking block in the frame.
• Set Screws And Hex Key — Two small set screws and an L-shaped hex key are packed with the kit.
• Black And Steel Finish — The external controls are black, and the trigger bar and housing springs are left bright steel.

Fit And What's Included

The kit is laid out for Glock 19 pattern frames and covers the frame side of the pistol only. Slide parts, the barrel, the recoil spring assembly and the frame itself are sold separately. Before you start a build, check that your frame is designed for Glock 19 lower parts. If you are new to installation, the pins and springs are small, so lay everything out on a clean bench first.