Glock OEM Trigger Housing with Ejector - 9MM
In stock
- SKU
- SP00322
- Material
- Polymer
Description
Glock 9mm Trigger Housing
This is a factory Glock trigger housing with the 9mm ejector already fitted. The trigger housing is the black polymer block that sits in the rear of the frame and holds the trigger mechanism in place. The ejector is the fixed steel blade on top that strikes each spent case and kicks it out of the ejection port. Order it as a replacement when your original housing or ejector is cracked, worn or damaged, or as a spare for a Gen 1 to Gen 3 9mm pistol.
Features
- Genuine Glock OEM Part — OEM means original equipment manufacturer, so this housing comes from Glock and matches the part your pistol left the factory with.
- Ejector Installed — The steel ejector is already mounted in the housing, so you do not have to source or press in a separate ejector.
- 9mm Ejector — The ejector is the 9mm version, intended for pistols chambered in 9x19mm.
- Black Polymer Housing — The body is molded in black polymer to the same design Glock uses in its own frames.
- Gen 1 to Gen 3 Fit — Fits Glock G17, G19, G26 and G34 pistols from the first three generations.
- Not For Later Models — It does not fit Gen 4, Gen 5, Glock 19X, Glock 45, Glock 42 or Glock 43 pistols.
- Housing Pin Hole — A cross hole at the base takes the trigger housing pin that locks the unit into the frame.
- Factory Tolerances — Glock builds it to its own specifications, so it lines up with the frame, trigger bar and slide the way the original did.
Fit and Compatibility
Check your pistol's generation before ordering. This housing is made for Gen 1, Gen 2 and Gen 3 G17, G19, G26 and G34 pistols in 9mm, and it will not fit Gen 4, Gen 5, 19X, G45, G42 or G43 frames. Because it comes from Glock with the ejector in place, it is a direct swap for a worn or broken factory housing on those models.
More Information
- More From Brand
- Similar Products