Mossberg 500/590 Heat Shield Kit - Parkerized Finish

Mossberg Heat Shield

A shotgun barrel heats up quickly during strings of fire, and a pump gun puts your support hand close to it. This Mossberg heat shield sits over the top of the barrel on 500 and 590 series shotguns, putting a perforated cover between the hot steel and your hand. It also gives the gun the familiar ventilated look of a duty or defensive pump.

Features

• Mossberg 500/590 Fit — Made by Mossberg for its own 500 and 590 pump-action shotguns.
• Ventilated Perforated Body — Rows of round holes along the length let air move around the barrel so heat can escape instead of building up under the shield.
• Hand Protection — The shield keeps your fingers off the bare barrel when it gets too hot to touch after sustained shooting.
• Parkerized Finish — A matte phosphate coating that resists corrosion, holds a film of oil well and cuts glare.
• Open Underside Design — The shield wraps over the top and sides of the barrel and leaves the bottom open.
• Hooked Front End — A formed hook at the muzzle end helps locate the shield on the barrel.
• Drilled Rear Mounting Tab — A tab with screw holes at the receiver end secures the shield in place.
• 12 Gauge Marking — The shield is roll-stamped "12 GA. Chambered for 2 3/4" and 3" U.S.A." along its side.

Fit And Finish

This is a factory Mossberg part, so it is built to the same pattern as the shields that ship on the company's own guns. Mossberg barrels come in several lengths and styles, so check the shield length against your barrel before installing. The Parkerized finish suits shotguns with a matching military-style finish and gives a dull, non-reflective surface.