Talon Grip for Smith and Wesson SD Series

SD Series Grip Wrap

The factory grip on a Smith & Wesson SD series pistol is fairly smooth, and it can slip once your hands are sweaty, wet or cold. This Talon Grip is a precut, adhesive-backed texture panel that sticks straight onto the polymer frame and gives your hand something to bite into. You don't need gunsmithing, tools or permanent frame stippling. It suits SD owners who carry, shoot regularly at the range, or want more control during fast follow-up shots.

Features

• Model-Specific Cut — Talon cuts the wrap to the contours of the Smith & Wesson SD series frame, so it follows the grip instead of being a universal sheet you trim yourself.
• Adhesive-Backed Panels — Peel off the backing and press the panels onto a clean, dry frame to fit them.
• Full Grip Coverage — As fitted, the texture covers both side panels and wraps around the front strap and backstrap, the front and rear faces of the grip.
• Aggressive Surface Texture — The raised surface grips your palm and fingers, so the pistol is less likely to shift in your hand under recoil.
• Logo Cutout — An opening around the Smith & Wesson grip medallion leaves the factory logo visible once the wrap is on.
• Low-Profile Thickness — The wrap adds texture without much bulk, so the grip keeps close to its original size in the hand.
• No Permanent Modification — Unlike stippling, where the polymer is melted to create texture, the wrap leaves the frame itself unaltered.
• Talon Grips Part T-708 — Part number T-708 identifies this kit as the SD series fit in the Talon range.

Fit and Installation

This kit is cut for Smith & Wesson SD series pistols. Check your model before you order, because Talon makes a separate wrap for each frame shape. Clean and degrease the grip first, line each panel up against the frame edges and the medallion cutout, then press it down firmly. Gentle warmth from a hair dryer helps the material settle into curves and around the edges.