USGI M9 Magazine Pouch - Multicam

Issue M9 Mag Pouch

This is a US Army single magazine pouch made for the Beretta M9, the 9x19mm service pistol carried by American troops for decades. It holds one spare magazine on a vest, plate carrier or belt, closed under a flap so the magazine stays put when you run, crawl or climb. It suits shooters running an M9 or 92-series pistol, reenactors building an accurate Multicam loadout, and collectors of US issue kit.

Features

• Single M9 Magazine Capacity — The pouch is sized to carry one Beretta M9 pistol magazine in 9x19mm.
• Multicam Pattern — The tan, brown and green Multicam print blends into a wide range of terrain and matches other Army Multicam gear.
• Cordura Nylon Construction — Cordura is a tough woven nylon that holds up to abrasion and repeated use in the field.
• Hook-And-Loop Flap — A covering flap presses shut onto a hook-and-loop panel on the front, so the magazine stays seated until you open it.
• Black Pull Tab — A stitched tab at the top of the flap gives your fingers something to grab when peeling it open, including with gloves on.
• MOLLE Attachment Strap — A vertical strap weaves through PALS webbing, the grid of nylon loops on military vests and belts, and locks with a tan snap.
• Drain Eyelet — A metal eyelet in the base lets water and grit drain out of the pouch.
• Genuine US Army Issue — This pouch was made for the US Army, not built by a commercial maker to look like it.

Built To Army Spec

The pouch is sewn from Multicam Cordura with webbing loops across the back and a single snap-closed strap for mounting. That layout fits any MOLLE-compatible surface, so it can ride on a plate carrier cummerbund, a chest rig or a padded battle belt. Because it is issued gear, it carries the same build and pattern as the kit soldiers used, which matters to anyone assembling an authentic loadout.