UTG AK Front Sight Tool

Zero Your AK Sights

The UTG AK Front Sight Tool lets you adjust the front sight on an AK-pattern rifle without fighting it with pliers or a punch. AK front sights are stiff by design so they hold zero under recoil, which makes them hard to move with general-purpose tools. This clamp grips the sight block and gives you controlled leverage for both elevation and windage, so the rifle hits where you aim.

Features

• Steel Construction — The body, screw and handle are steel, so the tool can take the force needed to move a tight factory sight.
• C-Clamp Body — The open, C-shaped frame fits over the front sight block and holds the tool steady while you work.
• Threaded Drive Screw — A fine-threaded screw advances slowly as you turn it, pushing the sight sideways in small, controlled steps for windage.
• Slotted Elevation Tip — The forked tip engages the front sight post so you can turn it up or down to raise or lower point of impact.
• Sliding T-Handle — A cross bar through the screw head gives you leverage by hand, and it slides to either side for clearance.
• Black Finish — A dark, non-reflective finish covers the tool and resists surface wear on the bench.
• Compact Size — The tool is small enough to keep in a range bag or cleaning kit for adjustments while sighting in.

How It Works

For windage, the clamp sits over the sight block and the screw presses against the windage drum, drifting it left or right a little at a time. For elevation, the slotted tip fits the front sight post, and turning the T-handle raises or lowers the post. Make small adjustments, fire a group, and check before moving the sight again.