UTG Pro AR-15 Carbine Length Drop In Quad Rail Handguard

Drop-In Quad Rail

The UTG Pro carbine length handguard replaces the factory handguard on a carbine-gas AR-15 and puts Picatinny rail on all four sides of the barrel. It is a drop-in design, so it fits between the delta ring and the front handguard cap the same way the original two-piece handguard does, with no barrel nut removal or gunsmithing. It suits owners who want to mount a light, laser, vertical grip or bipod on a standard carbine without rebuilding the front end.

Features

• Four Picatinny Rails — Top, bottom, left and right rails follow the Picatinny standard, the slotted mounting rail used by most modern optics and accessories.
• Drop-In Installation — The handguard installs in the factory handguard position, so you keep your existing barrel nut and front sight assembly.
• Two-Piece Clamshell Design — Upper and lower halves go on separately around the barrel, just like a standard carbine handguard.
• Carbine Length Fit — Sized for AR-15 rifles with a carbine-length gas system and the matching factory handguard.
• Numbered Rail Slots — Each rail is marked at every other slot with a side letter (T, L, R) and number, so you can return an accessory to the same spot after removing it.
• Oval Vent Cutouts — Three long oval openings on each side let heat escape from around the barrel and gas tube.
• Threaded Rail End Holes — Tapped holes sit at each end of the top rail.
• Black Finish — A matte black finish matches the receiver on most standard AR-15 builds.

Fit And Compatibility

This handguard is meant for carbine-length AR-15 uppers that use the standard delta ring and handguard cap. Because it clamps in the factory location, swapping back to the original handguard is just as simple. Check your gas system length before ordering, since mid-length and rifle-length guns need a longer handguard.