Volquartsen Remington 597 Target Hammer
Out of stock
- SKU
- VCRTH
Description
Lighter Remington 597 Pull
The Volquartsen Target Hammer replaces the factory hammer in a Remington 597 and cuts trigger pull weight by roughly half. A heavy, gritty factory pull makes it harder to hold steady through the break, and this part addresses it at the hammer itself. It installs without changes to the factory trigger guard, so it suits rimfire target shooters and competitors who want a better trigger without sending the rifle to a gunsmith.
Features
- Approximately 50% Lighter Pull — Trigger pull comes in around half the weight of the factory hammer, which makes it easier to hold your sight picture as the shot breaks.
- A2 Tool Steel — The hammer is machined from A2, an air-hardening tool steel known for wear resistance and dimensional stability.
- Hardened To Rc 58-60 — Hardness is held to 58-60 on the Rockwell C scale, the standard measure for hardened steel, so the engagement surfaces resist wear.
- Wire EDM Cut — Volquartsen cuts the profile by wire EDM, where an electrically charged wire erodes the steel to a precise outline, then fully machines the part from a single piece.
- Surface-Ground Hammer Notch — Each notch is individually surface ground to set the exact angle at which it meets the sear, the catch that holds the hammer cocked.
- Drop-In Installation — It replaces the factory hammer directly, with no modification to the factory trigger guard.
- Fits .22 LR, .22 WMR And .17 HMR — The hammer is compatible with all Remington 597 models in these three chamberings.
- Reliable Ignition — It keeps the rifle firing reliably across different ammunition brands and primer hardness, even at the lighter pull weight.
- Made In The USA — Volquartsen manufactures the hammer in the United States.
Fit And Construction
The hammer is a flat, single-piece steel part with a plain machined finish, cut by wire EDM and then fully machined rather than stamped or assembled. Because the notch is ground individually on every hammer, sear engagement is consistent from one part to the next. It fits every Remington 597 chambered in .22 LR, .22 WMR or .17 HMR and works with the factory trigger guard as-is.
More Information
- More From Brand
-
Shop all Volquartsen