Bianchi Model 7404 Baton Ring

Bianchi Baton Ring

The Bianchi Model 7404 Baton Ring carries a baton on your belt without a full holster or scabbard. A loop of black nylon web slides onto a 2.25-inch equipment belt, and a molded polymer ring hangs below it to hold the baton at your side, ready to draw. It suits patrol officers, security staff and anyone building out a US Army issue duty belt.

Features

• Standard And Side-Handle Fit — The ring takes both a straight baton and a side-handle baton, the type with a short grip set at a right angle to the shaft.
• Injection-Molded Polymer Ring — The ring is formed in one piece in a mold rather than assembled, so it has no seams or joints to work loose.
• Raised Edge Tab — A small lip stands up from the outer edge of the ring, opposite the belt loop.
• 1-Inch Nylon Web Loop — A strap of 1-inch nylon webbing wraps around the ring and is stitched closed to form the belt loop.
• Fits 2.25-Inch Duty Belts — The loop is sized for a 2.25-inch equipment belt, the wide outer belt that carries a holster, cuffs and radio.
• Textured Black Finish — The webbing has a tight textured weave in black that sits alongside other black duty gear.
• Bianchi AccuMold Line — It belongs to Bianchi's AccuMold range of molded and nylon duty accessories, part number 14414.
• Lightweight Build — Nylon and polymer keep the carrier light, so it adds little to a belt that is already heavily loaded.

Fit And Construction

The design uses two parts: a nylon web strap folded through the eye of a polymer ring and sewn shut. Thread your duty belt through the loop, position the ring where your hand falls naturally, then drop the baton through the ring until its handle stops it. Because it is open rather than enclosed, the ring makes for a fast draw and an easy return, and it holds either baton style on the same belt.