Glock OEM Slide Cover Plate

Factory Glock Cover Plate

This is Glock's own OEM slide cover plate, meaning it comes from Glock itself rather than an aftermarket copy. It is the small plate that slides into the back of the slide and holds the firing pin assembly in place. If yours is cracked, worn or lost, or if you are putting a custom plate back to stock, this returns the pistol to its factory configuration. It is also a sensible spare for armorers and anyone who details-strips their Glock.

Features

• Genuine Glock OEM Part — Glock part number SP00133, the same factory replacement plate supplied for the pistols it fits.
• Polymer Construction — The plate is molded from polymer like the original, so weight and fit match the stock part.
• Metal Insert — A bright metal section shows along the sides behind the polymer face, visible in both photos.
• Grooved Rear Face — Four horizontal grooves run across the lower half of the plate, the standard Glock pattern.
• Black Finish — Plain black that matches the factory slide finish.
• Gen 3 and Gen 4 Fit — Made for third- and fourth-generation Glock pistols.
• Rear-Of-Slide Installation — The plate slides down into the channels at the back of the slide, the same way the original comes out during a detail strip.

Fit and Compatibility

The SP00133 plate fits Gen 3 and Gen 4 Glock pistols, including models such as the 17, 19, 22, 23, 26, 27, 34 and 35. It does not fit the slimline Glock 42 and 43 or any Gen 5 model, which use different plates. Check your model and generation before ordering.