MSAP Cummerbund Assembly

MSAP Cummerbund Holder

This is the MSAP cummerbund back holder from Eagle Industries, a flat khaki panel made to mount on the MSAP plate carrier system. It anchors the cummerbund, the wide side band that wraps around the torso. It also adds three rows of webbing where you can hang more pouches. It suits anyone running or rebuilding an MSAP carrier who needs a replacement or a spare.

Features

• PALS Webbing Face — Three horizontal rows of PALS webbing, the stitched nylon loops behind MOLLE gear, run the full width of the front so you can mount pouches anywhere along it.
• Four MOLLE Mounting Straps — Four vertical straps on the back weave through matching webbing on the carrier to hold the panel flat and secure.
• Snap-Fastened Strap Ends — Each strap closes with a metal snap at the bottom, so the panel stays put once it is woven in.
• Rear Webbing Rows — Two rows of webbing on the back give the mounting straps something to pass through and lock against.
• Khaki Colorway — The panel and webbing are khaki, marked KH in the part number, so it matches other khaki MSAP components.
• Eagle Industries Construction — Heavy woven nylon body with bound edges and bar-tacked webbing, the reinforced stitching that keeps loops from pulling out under load.
• Labeled Part Number — The interior label reads PC-RK-B-MS-KH, MSAP Cumm Back Holder, so you can confirm it is the right part for your carrier.

Build And Fit

The label identifies the maker as Eagle Industries and carries contract number W911QY-08-D-0011 with a 09/08 date. The panel is part of the MSAP family and fits that carrier. Because the straps and webbing follow the standard MOLLE pattern, it will usually also attach to other gear with matching webbing. Check the spacing on your own carrier before you rely on it as a direct swap.