Ruger P89/P95 15-rd Magazine

Factory P-Series Magazine

This is Ruger's own 15-round 9mm magazine for its P-series pistols and the PC9 carbine. If your P89, P93, P94 or P95 came with only one or two magazines, this gives you a factory spare for range sessions, a reload on the belt, or a replacement for a worn original. It comes in Ruger's retail packaging, labeled as a genuine Ruger factory accessory.

Features

• 15-Round Capacity — Holds fifteen rounds of 9mm, also known as 9x19mm or 9mm Luger, the standard full-capacity load for these pistols.
• Genuine Ruger OEM — Made by Ruger as an original equipment part (OEM), so it matches the dimensions your pistol was built around.
• Broad P-Series Fit — The package lists the P89 (serial #304-7000 and above), P93, P94, P95 and PC9 carbine.
• Double-Stack Body — Rounds sit in a staggered column inside a wider body and taper to a single feed position at the top, which is how fifteen rounds fit in a duty-size grip.
• Witness Holes — Four holes along the back of the body let you see roughly how loaded the magazine is without stripping rounds out.
• Polymer Follower — A gray follower, the part the spring pushes up under the cartridges, guides each round to the feed lips.
• Flared Base Plate — A black polymer floorplate gives you a lip to grab if a magazine needs to be pulled free, and it seats flush against the grip.
• Caliber Marking — "9MM" is stamped on the side of the body so you can tell it apart in a mixed bag of magazines.

Check Your Serial Number

Ruger lists P89 compatibility only from serial #304-7000 upward, so owners of early P89s should confirm their serial before ordering. The P93, P94, P95 and PC9 are listed without restriction. The magazine catch cutout sits on the body in the factory position, so it locks into a compatible pistol the same way the magazine that shipped with it does.