French Dague SAS Paratrooper Dagger

French Combat Dagger

This is the French Army dague, a double-edged fighting knife made in France by Wildsteer and associated with French paratrooper and special forces units. It is a compact fixed blade built to ride on the belt or the thigh and stay put through jumps, patrols and vehicle work. Collectors of French military kit and anyone who wants a serious issue dagger rather than a commercial lookalike will find what they are after here.

Features

• Double-Edged Spear Point — Both edges are sharpened and meet at a centered point, the classic dagger profile built for thrusting and cutting from either side.
• N690 Stainless Steel — The blade is marked N690, a cobalt-alloyed stainless steel from Böhler valued for holding an edge while resisting rust.
• Black Blade Finish — A dark coating cuts down on glare and gives the steel an extra layer between it and the weather.
• Ridged Polymer Grip — The coyote tan handle has raised rings along its length and recessed thumb pads at each end so it stays locked in a wet or gloved hand.
• Integral Flared Guard — The handle swells out ahead of the blade to keep your hand from sliding forward onto the edge.
• Pointed Pommel With Lanyard Hole — A black pointed cap closes off the handle and is drilled through for a retention cord.
• Polymer And Webbing Sheath — A tan molded polymer body holds the blade, with a nylon webbing extension and a snap strap that secures the handle.
• Leg Strap And Belt Mount — A buckled thigh strap with a hook-and-loop keeper and a separate round belt mount let you carry it on the hip or tied down on the leg.
• Mounting Hardware Included — Screws, nuts, a driver bit, a small wrench and an Allen key come in the set so you can configure the sheath yourself.
• Marked France — The blade carries the Wildsteer logo along with FRANCE and N690 stampings near the guard.

Issue Pattern Sheath System

The sheath is designed as a modular carry system. The polymer body takes the webbing loop and leg strap for drop-leg wear, or bolts to the round mounting plate for a belt or gear setup, and the included tools handle the swap. Blade, grip and sheath all share the same coyote tan and black scheme, so the whole kit matches modern French Army equipment.