G3 Buffer Pin 2-pack

G3 Buffer Pin Spares

This pack holds two buffer pins for the G3 rifle's buffer assembly, drawn from German Army stores. A small pin like this is easy to lose during a strip-down and hard to find once it's gone. Two in the bag give G3 owners, builders and restorers one to fit and one to keep in the parts drawer.

Features

• Two Pins Per Pack — You get a pair, so one can go into the rifle and the other stays on hand as a spare.
• German Army Issue — These are genuine Bundeswehr parts supplied for the G3, not aftermarket copies.
• Flanged Head — A raised collar near one end acts as a shoulder, stopping the pin at a set depth when seated.
• Stepped Profile — The pin narrows below the flange to a longer cylindrical shank, as shown in the photograph.
• Machined Construction — Fine turning lines on the shank show it was cut on a lathe to a consistent diameter.
• Dark Finish — The pin carries a dark finish that matches the other small parts of the G3 buffer assembly.
• G3 Buffer Assembly Fit — The pins are made for the buffer assembly of the G3 battle rifle, the 7.62mm service rifle of the West German armed forces.

Bundeswehr Issue Parts

The G3 served as the standard German Army rifle for decades. Parts made for it were built to the army's own specification, not to a maker's interpretation. Collectors and restorers want issued spares like these when keeping a G3 correct to its service pattern. Check the pin against your rifle before fitting, because builds and parts kits can differ.