G3 Buffer Screw 3-pack

G3 Buffer Screws

This is a set of three buffer screws for the G3 battle rifle, taken from German Army stocks. The buffer screw is a small part of the rifle's recoil buffer assembly, and small parts are what go missing or get chewed up during a rebuild. A three-pack lets you replace a damaged screw and keep two in the parts drawer. G3 owners, builders and armorers who keep spares on hand will get the most use from it.

Features

• Genuine German Army Issue — These screws come from German military stocks rather than an aftermarket maker.
• Three-Screw Pack — You get three identical screws, so one can go in the rifle and two can stay in reserve.
• Flanged Head — A wide collar under the head spreads the clamping load over a larger area and seats the screw flush against the part it holds.
• Slotted Head — A slot is cut across the head for driving the screw in and out.
• Partially Threaded Shank — A smooth, unthreaded section below the head leads into the threads, so only the end of the screw does the gripping.
• Chamfered Tip — The beveled end helps the screw start straight in its hole without cross-threading.
• Dark Matte Finish — The screws have the same dark, non-reflective finish as the rest of the rifle's small parts.

Original Military Parts

The G3 was the standard service rifle of the German Bundeswehr for decades, and these screws were made to its original military specification. Factory-issue parts fit the way the designers intended, which matters when you are rebuilding a rifle to correct spec. If you run a G3-pattern rifle from another source, compare these against your existing screw before installing.