Glock OEM 9mm Extractor - Old Style

Glock Non-LCI Extractor

This is a factory original Glock extractor for 9mm pistols built before the loaded chamber indicator arrived. The extractor is the hooked part on the right side of the slide that grips the rim of each cartridge case and pulls the spent brass out of the chamber, so a worn or chipped one causes failures to extract. Owners keeping an older 9mm Glock running, and anyone restoring an earlier generation slide to original spec, will want this part.

Features

• Glock OEM Part — Made by Glock to its own original equipment specification, the same part the factory installs, rather than an aftermarket copy.
• Old-Style Non-LCI Design — It has no loaded chamber indicator, the tab on newer extractors that shows when a round is chambered, which matches how older slides were built.
• 9mm Caliber — The claw is sized for 9mm cartridge rims and will not suit Glocks in other calibers.
• For Earlier Generation Slides — Intended for replacement and restoration work on older 9mm Glock pistols that originally shipped with the non-LCI extractor.
• Not Compatible With The G43 — The single-stack G43 takes a different extractor, so this part will not fit it.
• Dark Metal Finish — The extractor has a dark finish with a recessed face and carries a factory stamp, as shown in the photograph.
• Part Number SP00098 — Glock's factory designation for this old-style 9mm variant, useful for matching against parts lists and armorer references.

Fit And Compatibility

Check which extractor your slide currently uses before ordering. If your 9mm Glock has a flush extractor with no indicator tab, this is the matching factory replacement. Slides set up for the later LCI extractor and the G43 need a different part.