Ontario Jericho Hanger

Heavy-Duty Gear Hanger

The Ontario Jericho Hanger is built for the gear a wire or department-store hanger can't hold: loaded vests, packs, heavy jackets and other tactical, sporting and outdoor kit. Ontario Knife Company rates it to 150 pounds and gives it a thick, reinforced frame so it holds its shape under that weight. The cutouts, hooks and tabs across the body give you several ways to hang straps, belts and accessories, so a full setup can stay together on one hanger instead of in a pile on the floor.

Features

• 150 Lb Weight Capacity — The hanger is rated to carry up to 150 pounds, enough for loaded load-bearing gear and heavy outerwear.
• Injection-Molded Polypropylene — The frame is a single piece of rigid polypropylene formed in a mold, so there are no joints or welds to work loose.
• Thick Reinforced Frame — The 0.75-inch-deep body is shaped to resist the bending and sagging that ruin ordinary hangers under heavy loads.
• Multiple Holes And Cutouts — Large round openings at each end and in the center, plus three smaller holes below the neck, give you places to loop straps, cords or carabiners.
• Hooks And Tabs Along The Base — Three open tabs on the bottom edge hold belts, slings or lanyards beneath the main garment.
• Notched Shoulder Ends — Notches at both outer shoulders give straps and shoulder pads a spot to sit so they stay put.
• Fits Standard Closet Rods — The single top hook is sized for normal hanging rods, so it works in a regular closet, gear room or locker.
• Made In USA — Ontario Knife Company manufactures the Jericho Hanger in the United States.

Build And Dimensions

The Jericho measures 20.0 x 11.75 x 0.75 inches and weighs 11.9 ounces, so it is wider and much stiffer than a typical clothes hanger while still light to move around. Its one-piece polypropylene construction holds up in damp gear rooms and does not rust. The unit pictured is black.