Ruger SR9 - 10-Round Magazine

Factory SR9 Magazine

This is Ruger's own 10-round magazine for the SR9 and SR9E pistols, chambered in 9mm Luger (9x19mm). It is a factory OEM part, meaning it comes from the company that made the pistol, so the fit and feed geometry match what the gun was designed around. Owners pick it up as a spare for the range, a backup for carry, or a replacement for a worn original.

Features

• 10-Round Capacity — Holds ten rounds of 9mm Luger, a size that also works where local rules cap magazine capacity at ten.
• Factory OEM Part — Made by Ruger under part number 90325 and marked SR9 9x19mm with the Ruger logo on the body.
• Blued Steel Body — The tube is steel with a bluing finish, a chemical treatment that darkens the metal and helps it resist rust.
• Double-Stack Design — Rounds sit staggered in two columns, which keeps the magazine short enough to fit the SR9 grip.
• Numbered Witness Holes — Holes down both sides, numbered 4 through 10, show how many rounds are loaded without emptying the magazine.
• Polymer Follower and Baseplate — The follower, the part the spring pushes up under the cartridges, and the baseplate are polymer, and the baseplate carries a 9x19mm marking.
• Matte Black Finish — A low-glare black finish matches the pistol and does not reflect light.
• Made in Italy — The body is stamped Made in Italy on the side.

Build and Fit

The magazine fits the Ruger SR9 and SR9E. The steel body takes the wear of repeated loading and reholstering, while the polymer baseplate gives a flat surface to seat the magazine firmly with the palm. Because it is the factory part, it drops in and locks up the same way the magazine that shipped with the pistol does.