Volquartsen V-Locking Block for Ruger 10/22

Tighter Locking Block

The Volquartsen V-Locking Block is a replacement for the factory headspacing block in the Ruger 10/22, the part that sits behind the chamber and holds the barrel in position. Where the stock block relies on a single contact point, Volquartsen's V-notch design beds the barrel more precisely and removes play at the barrel-to-receiver joint. It is a common first upgrade for shooters chasing better consistency from their 10/22 without touching the barrel or trigger group.

Features

• V-Notch Bedding Surface — The angled V cut into the top seats the round barrel shank on two faces instead of one, holding it in alignment every time the block is tightened.
• Reduces Barrel Play — A firmer, more repeatable grip on the barrel shank helps the barrel return to the same point of impact shot to shot.
• Direct Drop-In Fit — Replaces the factory 10/22 locking block in the same recess using the two original screws, with no permanent modification to the receiver.
• Steel Construction — Machined from steel for durability under repeated clamping and recoil.
• Two-Screw Clamping — Twin holes carry the standard retaining screws that draw the block up against the barrel shank.
• Fits Ruger 10/22 And Charger — Compatible with standard Ruger 10/22 rifles and 10/22-pattern receivers that use the factory block design.
• Pairs With Aftermarket Barrels — A tight-fitting block supports the gains from a bull barrel or match barrel by removing slop at the joint.

Fit And Installation

Installation is straightforward for anyone comfortable field-stripping a 10/22: remove the barrel, swap the old block for the V-Locking Block, and reinstall using the two factory screws. The part is built to the dimensions of the standard Ruger locking block, so it drops into the same pocket in the receiver. Verify it against your own rifle before final torque, as it is designed for the factory-pattern 10/22 and Charger receivers.