AR-15 A2 Pistol Grip

Classic A2 Rifle Grip

The United Defense AR-15 A2 Pistol Grip copies the shape of the A2 pattern, the grip introduced on the M16A2 rifle and still the most common profile on AR-15s today. It replaces the handle your firing hand holds behind the trigger. Use it to put a worn or cracked grip back to standard, finish a build with traditional lines, or swap out an aftermarket grip that never felt right.

Features

• A2 Finger Swell — A single ridge on the front strap sits between your middle and ring fingers, so your hand settles at the same height every time you take hold.
• Checkered Side Panels — Raised diamond-pattern texture on both sides gives your palm and fingertips something to bite into when your hands are wet or gloved.
• Grooved Rear Edge — Vertical ribs run along the back of each side panel for added purchase where the web of your hand presses in.
• Flared Base — The bottom of the grip widens at the front and rear, giving the lower fingers and heel of the hand a stop.
• Ambidextrous Profile — Both sides are identical, so the grip works the same for left- and right-handed shooters.
• Matte Black Finish — A flat, low-glare black surface that matches the receivers and furniture on most AR-15 rifles.
• Standard AR-15 Fit — Built to the A2 pattern, so it mounts to a standard AR-15 lower receiver the same way as the factory grip.

Fit And Installation

The grip attaches to the lower receiver, the part of the rifle that holds the trigger group and magazine well, with a single grip screw from underneath, just like the original. Take care with the safety selector spring and detent when you remove the old grip, as they sit under the top of the grip. If you already know the feel of a standard A2 grip, this one will be familiar from the first time you pick the rifle up.