Beretta 96 Magazine 40 S&W 11-round

Factory Beretta 96 Magazine

This is a factory Beretta magazine for the Beretta 96 family, chambered in .40 S&W and holding 11 rounds. It is OEM, meaning original equipment from the pistol's own manufacturer, built to Beretta's specifications and tolerances rather than copied by an aftermarket maker. Use it as a spare for carry, a backup for duty, or an extra for range days so you spend less time reloading at the bench.

Features

• .40 S&W Caliber — The tube is sized for .40 S&W cartridges and is stamped "CAL.40 S.&W." on the side so it cannot be mistaken for a 9mm 92-series magazine.
• 11-Round Capacity — Each magazine holds 11 rounds of .40 S&W.
• Steel Magazine Body — The body is formed from steel, with the fluted sides and feed lips typical of Beretta's 90-series pattern.
• Blued Finish — Bluing is a chemical treatment that turns the steel a deep black and gives it a measure of protection against rust.
• Polymer Follower — The follower, the platform that pushes rounds up toward the chamber, is injection-molded polymer.
• Steel Spring — A steel spring drives the follower and feeds each round into position.
• Polymer Baseplate — The black polymer floorplate closes off the bottom of the tube and gives you a solid surface to seat the magazine.
• Witness Hole — A slot in the side of the body lets you see the stack and check how loaded the magazine is.
• Made In Italy — The body is stamped "MADE IN ITALY" and the magazine is manufactured there for Beretta.

Fit And Compatibility

This magazine fits the Beretta 96, 96A1, 96FS, 96G, 96D, 96 Brigadier, 96 Elite, 96 Stock and 90-Two pistols. It also works in the Beretta CX4 carbine when the rifle is set up with the 90 Series magazine well insert and magazine release. The manufacturer part number is JM80399HC.