Don't Bro Me Morale Patch

Round PVC Morale Patch

The Don't Bro Me morale patch from 5ive Star Gear says what a lot of people think when a stranger gets too familiar. A morale patch is a non-regulation patch worn to show some personality, and this one fits on caps, packs, plate carriers and range bags. It is molded PVC with a hook backing, so you can put it on, move it or take it off whenever you like.

Features

• Molded PVC Construction — The patch is cast from flexible PVC, a rubbery plastic that holds up to wet weather better than embroidered thread.
• Raised 3D Lettering — The text stands up from a textured background, so the message stays crisp and easy to read.
• Two-Tone Split Design — The black upper half carries "DON'T BRO ME" in tan, and the tan lower half reads "IF YOU DON'T KNOW ME" in black.
• Sewn Hook Backing — The hook side of a hook-and-loop fastener is stitched to the back, so the patch grips any fuzzy loop panel and peels off when you want to swap it.
• Stitched Border — Gray stitching around the rim holds the backing in place and frames the design.
• 2.25-Inch Diameter — At about 2.25 in (5.7 cm) across, it fits cap fronts, pack lids and small loop fields.
• Lightweight — It weighs about 0.10 lb, so it adds nothing noticeable to a hat or carrier.
• Easy-Clean Surface — The PVC face resists stains and cleans up with soap and water.

Construction And Fit

5ive Star Gear is a TRU-SPEC brand, and this patch follows the usual PVC morale patch layout: a molded face with hook material sewn to the back. It attaches to any loop surface, including the panels on tactical caps, backpacks, plate carriers and jackets. Nothing is glued or ironed on, so you can reposition it or move it to another piece of kit without leaving a mark.