ETS Magazine for M&P Shield 9 - 9 Round

Clear 9-Round Shield Mag

This ETS magazine holds nine rounds of 9mm for the Smith & Wesson M&P Shield. The body is translucent polymer, so you can check how many rounds are left by looking at it, without unloading or guessing. Shield owners who carry daily often use it as a spare, and it also works as an extra magazine for range sessions.

Features

• Fits M&P Shield 9mm — The body is molded with "Fits SHIELD 9mm" and is built for the single-stack Smith & Wesson M&P Shield in 9mm.
• 9-Round Capacity — It holds nine cartridges, and the count is molded into the lower body so you can identify it on the bench.
• Translucent Polymer Body — The clear, lightly smoked shell shows the cartridges and spring inside, so your remaining round count is visible at a glance.
• 9x19mm Chambering — It is made for standard 9mm Luger ammunition, also listed as 9x19mm.
• Black Polymer Follower — The follower is the part the spring pushes up under the rounds, and it sits in black polymer at the top of the stack.
• Coil Spring — The full-length spring pushes each round up to the feed lips and stays visible through the body.
• Witness Window — A small square opening near the top of the body gives another reference point when you check the load.
• Flat Black Baseplate — A flat polymer floor plate closes off the bottom and gives you something to grip when stripping the magazine out.
• Made In USA — "MADE IN USA" is molded into the magazine body.

Build And Fit

ETS molds the body from clear polymer and marks the fit, capacity and origin directly into it with the ETS logo, so there are no labels to wear off. The black follower and baseplate stand out against the translucent shell. The magazine is a 9-round, 9mm design for the M&P Shield, so check that your pistol is the 9mm Shield model before ordering.