Ruger 10/22 Scope Mount

Ruger 10/22 Base Set

This two-piece Weaver base set gives your Ruger 10/22 a solid mounting surface for a scope or red dot. The front and rear bases bolt directly to the receiver's factory-tapped holes, then accept standard Weaver-style rings so you can finish the build with the optic of your choice. It is the usual first step when you want to move past the open sights on a 10/22.

Features

• Two-Piece Base Set — Separate front and rear bases mount to the Ruger 10/22 receiver and leave the ejection port clear.
• Weaver-Style Top — The slotted top accepts any standard Weaver or Picatinny-pattern rings, so you choose the ring height to suit your optic.
• Aluminum Construction — Machined from aluminum to keep weight low without adding bulk over the receiver.
• Cross-Lock Slots — The crosswise slots lock with the recoil lug on crossbolt rings so the optic cannot slide forward or back under recoil.
• Direct Receiver Fit — Bases line up with the factory-drilled and tapped holes on the 10/22 receiver, no gunsmithing required.
• Serrated Seating Surface — The underside is grooved to grip the receiver and resist shift once the screws are torqued.
• Black Finish — A matte black finish matches most rifle receivers and cuts glare.
• Mounting Holes Provided — Each base has countersunk screw holes for a flush, low-profile fit.

Fit And Build

The set is cut for the Ruger 10/22 receiver and uses the rifle's existing screw holes, so installation is a matter of fitting the two bases and torquing the screws. The Weaver-style top means you are not locked into one brand of rings; pick the ring height that clears your scope's objective bell or seats a compact red dot low. Rings and mounting screws are not included unless your 10/22 already shipped with them.