Mosin Nagant Parts & Accessories • 1891–Present
Mosin Nagant Parts
The Mosin Nagant bolt-action rifle served Imperial Russia, the Soviet Union, Finland, and dozens of client states from 1891 through the 1960s — one of the longest production runs of any military rifle in history and the platform behind an estimated 37 million rifles produced across Tula, Izhevsk, Sestroretsk, and licensed arsenals. Keep Shooting stocks 10 parts and accessories covering the canonical military kit: the M91/30 bayonet the rifle was zeroed with, the sling, scope mount, cleaning rod, oil bottle, rifle tool, and TekMat for maintenance, and the ammo pouch from the original issued kit. Most are genuine surplus or surplus-spec accessories sourced from US importers of the post-Cold-War Russian, Bulgarian, Hungarian, and Polish arsenal liquidations.
Mosin Nagant Parts at Keep Shooting
The Mosin Nagant — originally the Trekhlineynaya vintovka obraztsa 1891 goda (“three-line rifle, Model 1891”) — is the bolt-action rifle co-designed by Russian Imperial Army officer Sergei Ivanovich Mosin and Belgian arms designer Léon Nagant, adopted by Tsar Alexander III in 1891 and produced continuously for the better part of a century by arsenals at Tula, Izhevsk, Sestroretsk (Imperial Russia and the Soviet Union), Tikkakoski and VKT (Finland, from captured and rebuilt rifles), Châtellerault and Remington (allied production during World War I), plus licensed runs in Poland, Hungary, Romania, Czechoslovakia, and China. Total production estimates run past 37 million rifles, making the Mosin one of the most-produced military rifles in history. The dominant variant in US collector and shooter hands is the M91/30 — the 1930 Soviet-era modernization of the original 1891 rifle, with a shorter barrel, hex or round receiver, and the cruciform spike bayonet that the rifle was originally zeroed with attached. Keep Shooting carries 10 parts and accessories covering the canonical kit: Mosin Nagant Bayonet M91/30, Mosin Nagant Sling, Scope Mount, Cleaning Kit, Cleaning Kit Pouch, Cleaning Rod, Rifle Tool, Oil Bottle, TekMat, and Ammo Pouch.
The M91/30 Bayonet — A Sighted-In Rifle Component
The Mosin Nagant M91/30 bayonet is the cruciform spike bayonet issued with the rifle from the 1891 original through the entire Soviet production run — a 17-inch quadrangular (four-edged cross-section) steel blade with a flat screwdriver-shaped tip and a locking ring that seats over the muzzle. The bayonet is not a secondary accessory on the Mosin platform; it is part of the rifle’s sighting system. Imperial Russian specifications and Soviet doctrine both called for the rifle to be zeroed at the factory with the bayonet fixed in the deployed position. The weight and position of the bayonet shift the rifle’s point of impact by a measurable amount; a Mosin zeroed bayonet-fixed will shoot meaningfully high (typically 6 to 12 inches at 100 yards depending on the load) when the bayonet is removed. For collectors and shooters running historically-correct setups, the bayonet is the canonical accessory.
Two practical notes for the M91/30 bayonet: the flat screwdriver tip was deliberate military engineering — it doubles as a field tool for adjusting the rear sight, loosening the trigger guard screws, and the small handful of slotted-screw maintenance tasks that come up on the Mosin in the field. And the cruciform cross-section was chosen for wound geometry; the four-edged profile creates a wound channel that resists closure and bleeds more aggressively than a single-edged knife blade, which is why most major militaries moved away from spike bayonets by the late 20th century in favor of more versatile knife-bayonet hybrids. The M91/30 bayonet is among the last cruciform spike designs in widespread military issue.
7.62x54R — The Cartridge That Outlived Three Empires
The Mosin Nagant is chambered in 7.62x54mmR — the rimmed Russian service cartridge designed alongside the rifle in 1891 and still in active military service today, more than 130 years after its adoption. The cartridge has outlived Imperial Russia, the Soviet Union, and the Cold War — the only rifle cartridge in modern military service with that kind of continuity. The 7.62x54R powers not just the Mosin but the SVD Dragunov designated marksman rifle, the PKM general-purpose machine gun, and the Tigr civilian variants of the Dragunov — meaning Soviet/Russian frontline forces have used the same cartridge for sniping, squad automatic fire, and bolt-action service since before World War I.
The relevance for parts and accessories: most US-market 7.62x54R ammunition through the 1990s and 2000s was corrosive-primed military surplus from Russian, Bulgarian, Czech, and Hungarian stockpiles. Corrosive primers leave a salt residue in the bore that draws moisture and produces rust within 24 hours if not cleaned promptly with a water-based or ammonia-based solvent (the alkaline compartment of the original two-chamber oil bottle is exactly this). The Mosin’s cleaning rod, kit, oil bottle, and rifle tool were not optional accessories — they were the rifle’s survival kit, used after every range session with corrosive surplus ammunition. For 7.62x54R ammunition stocks (when available), see the rifle ammunition catalog.
The Issued Cleaning Kit — Rod, Tool, Oil Bottle, Pouch
The Mosin’s issued cleaning kit is one of the most complete bolt-action rifle cleaning systems any military ever fielded, and Keep Shooting carries the four canonical components plus the modern TekMat addition:
The Mosin Nagant Cleaning Rod is a sectional steel rod that threads together into a full-length bore rod. The rod stores in three or four pieces in the cleaning kit pouch and assembles in seconds when needed. Most Mosin rifles also have a captive cleaning rod that rides in a channel under the barrel, threaded through the bayonet stud at the muzzle and retained at the wood-line by a stud catch; the sectional rod in the cleaning kit is the spare and the workshop rod for thorough cleanings.
The Mosin Nagant Rifle Tool is the small combination wrench-and-screwdriver used to disassemble the bolt for cleaning, adjust the firing pin protrusion (a critical Mosin maintenance step — the firing pin must protrude between 0.075″ and 0.095″ from the bolt face for reliable primer ignition), and serve as the muzzle-cover removal tool. The tool is small, cheap, and irreplaceable — the rifle cannot be properly serviced without one.
The Mosin Nagant Oil Bottle is the canonical two-chamber tin issued with every rifle. One chamber holds alkaline solvent (originally a sodium-based water/lye solution, modern replacements use ammonia-based bore solvents) for neutralizing corrosive-primer salts immediately after firing. The other chamber holds neutral oil for protecting the steel after cleaning and lubricating moving parts. The two-chamber design is purpose-built for the corrosive-ammo problem the Mosin’s primary cartridges always presented.
The Mosin Nagant Cleaning Kit is the full assembled set — rod sections, tool, oil bottle, brushes, and patches — and the Cleaning Kit Pouch is the canvas-and-leather field pouch that holds the kit on the soldier’s belt or in the kit bag. The Mosin Nagant TekMat is the modern addition: a 12″ × 36″ padded cleaning mat from TekMat printed with the rifle’s exploded parts diagram, protecting the workbench from oil and solvents while serving as a reference chart during disassembly.
Slings, Scope Mounts & Carry
The Mosin Nagant Sling is a surplus-spec replacement from NcSTAR, replicating the original Soviet leather sling pattern that loops through the sling-slot cutouts on the Mosin’s buttstock and front handguard. Most original Mosin slings in the surplus market are 70+ years old and in marginal condition; a modern replacement is the practical choice for shooters who want to actually carry the rifle.
The Mosin Nagant Scope Mount is a no-drill replacement rear sight leaf that swaps in for the factory rear sight base, providing a Picatinny rail platform above the bore axis for long-eye-relief scopes or red dot optics. The no-drill design is critical because most Mosins are valuable collectible rifles (especially the Imperial-era hex receivers and the Finnish-rebuild M28/30 and M39); a permanent drilled-and-tapped mount destroys collector value, while the no-drill leaf installs and removes with two screws.
The Mosin Nagant Ammo Pouch is a surplus-spec canvas-and-leather hip pouch that holds two 5-round stripper clips — the Mosin is fed by stripper clip from the top of the open action, not by detachable magazine, and the canonical ammo carry method has always been the leather/canvas hip pouch of pre-loaded clips. The pouch is the canonical cartridge-carry accessory from the original issued kit.
Surplus Sourcing & the Post-2014 Reality
Most Mosin Nagant parts in the US market are either genuine military surplus from Russian, Bulgarian, Hungarian, Polish, and Czech arsenal liquidations of the post-Cold-War period (1990s through early 2010s) or surplus-spec replacements manufactured to original military patterns by current US, Chinese, and Eastern European producers. The 2014 ATF import restrictions on Russian-origin firearms and parts, followed by the broader sanctions framework of 2022, effectively cut off the direct flow of genuine Russian-arsenal Mosin parts to the US market. The supply that remains in circulation came in before 2014; once it’s gone, it’s gone. Bulgarian, Hungarian, Polish, and Romanian surplus continues to trickle in through various import channels but at higher prices and lower volumes than the pre-2014 era. Keep Shooting’s Mosin parts inventory reflects this mix — some items are last-chance genuine surplus, others are modern surplus-spec replacements built to original patterns.
Pairing & Cross-References
Because the Mosin Nagant sits in the bolt-action military-rifle bucket alongside other WWI and WWII service rifles, the natural pairings are the other military-rifle parts sub-buckets in the catalog. For the US-issued M1 Garand semi-automatic that replaced the Springfield bolt-action in American service, see the M1 Garand parts catalog. For the M14 (the post-WWII replacement for the Garand, and the platform behind the M1A civilian variant), see the M14 parts catalog. For the broader military-rifle parts catalog covering surplus rifles outside the major named platforms, see the military surplus parts catalog. For Russian-origin military surplus gear (uniforms, field gear, headwear, and equipment), see the Russian Army surplus collection. For the parent gun parts catalog covering AR-15, AK, 1911, Glock, and the rest of the platform-specific sub-buckets, see the parent category.
Frequently Asked Questions — Mosin Nagant Parts
Keep Shooting carries a wide selection of Mosin Nagant Parts products from trusted brands. Browse our catalog to see the full range, and use the filters on the left to narrow by brand, price, or product type.
Yes! All orders over $49.95 qualify for free shipping, including Mosin Nagant Parts products. Orders typically ship within 1–2 business days.
Keep Shooting offers hassle-free returns on Mosin Nagant Parts products. If you're not completely satisfied, contact our customer service team for a return authorization. All products must be in original, unused condition.
If you need help choosing the right Mosin Nagant Parts product, our team is available to assist. Check individual product descriptions for detailed specifications, or contact us directly and we'll help you find the best fit for your needs.