Springfield Armory XD-S 40 Magazine - with Sleeves

XD-S .40 S&W Magazine

This is a factory Springfield Armory magazine for the XD-S pistol chambered in .40 S&W. It holds seven rounds and comes with sleeves that fill the gap between the pistol's short grip and the magazine's extended base, so your little finger has somewhere to sit. It suits XD-S owners who want a spare for the range, a backup for concealed carry, or a fuller grip than the flush magazine allows.

Features

• Factory Springfield Armory Part — Made by the pistol's own manufacturer for the XD-S, so fit and feeding match the original equipment.
• .40 S&W Chambering — Built for the .40 S&W cartridge and intended only for XD-S pistols in that caliber.
• 7-Round Capacity — Carries seven rounds in a single stack, the body extending just below the grip to make room for them.
• Stainless Steel Body — The bright stainless tube resists rust from sweat and handling, which matters on a carry gun.
• Numbered Witness Holes — Holes marked 2 through 7 down the back of the body let you see at a glance how many rounds are loaded.
• X-Tension Sleeves Included — Black polymer sleeves bearing the XD logo slide over the magazine and close the gap between the frame and the baseplate.
• Textured Grip Sleeve — Molded ridges on the sleeve continue the feel of the pistol's grip down to the base of the magazine.
• Black Polymer Follower — The follower inside the tube lifts each cartridge into position as the slide cycles.

Fit And Compatibility

This magazine fits the Springfield Armory XD-S in .40 S&W. It will not work in 9mm or .45 ACP XD-S pistols, or in the full-size XD and XD(M) lines. With a sleeve fitted, the extension sits flush against the frame and reads as part of the grip rather than a gap below it.