AR15 Roll Pin Punch

Features

1. AR-15 Bolt Catch Specific — Purpose-built to install and remove the bolt catch roll pin on AR-15 / M4 pattern lower receivers without marring the finish.
2. Full Steel Construction — One-piece solid steel body holds up to repeated hammer strikes and won't bend or deform under load.
3. Flat-Sided Profile — Sculpted flat on one side so the tool slides cleanly into the tight pocket between the bolt catch and the receiver wall.
4. Correctly Sized Tip — Tip is dimensioned to the AR-15 bolt catch roll pin, eliminating the slip and walk that comes with using a generic punch.
5. Pin Starter Design — Holds the roll pin in alignment so you can start it cleanly with a single hand and avoid scratching the magwell or receiver.
6. Dual Install and Removal Use — Works for both driving the bolt catch pin in during a build and knocking it back out for service.
7. Gunsmith and Home Builder Friendly — Sized and shaped for the most common headache point on a stripped-lower build, saving time on every assembly.
8. Compact and Bench-Ready — Small enough to live in your AR build kit or armorer's pouch alongside your punch set and brass hammer.