Walther P1 Mag Floor Plate

P1 Magazine Floor Plate

This is an original German Army floor plate for the Walther P1 magazine. The floor plate is the flat base that closes the bottom of the magazine and keeps the spring and follower inside. When one goes missing or gets bent, the magazine can't hold rounds reliably. P1 owners, collectors restoring a Bundeswehr pistol, and anyone keeping spare magazines running use this part to bring a magazine back to full order.

Features

• Fits Walther P1 Magazines — Made for the single-stack magazine of the Walther P1, the 9x19mm service pistol of the West German Bundeswehr.
• Genuine German Army Issue — Original government stock, so it matches the factory magazine instead of an aftermarket approximation.
• Raised Locking Dimple — A round stud stamped into the plate helps lock it in position on the base of the magazine.
• Forked Rear End — A slot cut into one end gives the plate its correct shape for seating on the magazine body.
• Angled Front Tip — The opposite end is tapered and bent at a slight angle, following the original pattern.
• Flat Stamped Construction — Pressed from a single piece of metal, with no small parts to lose.
• Dark Matte Finish — A dark, textured surface that matches the finish of issued P1 magazines.

Bundeswehr Service Part

The Walther P1 is the postwar development of the P38 and was the standard sidearm of the West German armed forces for decades. This floor plate comes from German Army parts stock and follows the original specification: a flat stamped plate with a forked end, an angled tip, and a raised locking dimple. For a shooter it is a direct replacement part. For a collector it keeps a P1 magazine correct to issue.