Texas Flag Morale Patch

Texas Flag Morale Patch

This is the Lone Star flag from Mil-Spec Monkey, sized at 3 x 2 inches to fit the loop panels on most tactical gear. It is fully embroidered and has a hook backing, so you can put it on a plate carrier, pack, jacket or ball cap and move it whenever you like. It suits Texans and anyone who wants to show state pride on their kit without sewing anything.

Features

• Fully Embroidered Face — The whole design is stitched in thread rather than printed, so the flag keeps its texture and colour with wear.
• 3 x 2 Inch Format — At about 7.6 x 5.1 cm it matches the common flag-patch size used on loop panels across carriers, packs and caps.
• Hook Fastener Backing — The back has sewn-on hook material, the stiff half of a hook-and-loop closure, which grips any soft loop field.
• Merrowed Border — A tightly overlocked edge wraps the perimeter to stop the patch fraying and keep the outline clean.
• Lone Star Layout — The vertical blue bar carries a single white star, with white and red horizontal stripes to the right, following the Texas state flag.
• Several Colorways — The patch comes in multiple versions, including subdued options in Desert, Multicam and Black and White alongside the full-colour flag shown.
• Removable Placement — You can peel it off and move it between a hat, a jacket sleeve and a pack in seconds.
• Mil-Spec Monkey Design — Made by a U.S.-based maker that specializes in morale patches for tactical and outdoor gear.

Fit And Attachment

The patch fits any surface with a loop field, which is the soft, fuzzy panel found on most plate carriers, assault packs, tactical jackets and patch-ready ball caps. Because it only has hook material on the back, it will not attach to bare fabric or MOLLE webbing unless there is a loop panel there. The 3 x 2 inch footprint sits comfortably on a standard shoulder or front ID panel next to other patches.