Weaver Remington 597 Scope Mount Base

Remington 597 Scope Base

This Weaver base gives the Remington 597 semi-auto rimfire a solid platform for a riflescope or red dot. It is a one-piece aluminum rail made for the 597 receiver, so you are not adapting a generic part. It suits owners mounting their first optic as well as shooters replacing a worn or mismatched base.

Features

• Made For The Remington 597 — The base is shaped and drilled for the Remington 597 receiver, so the hole pattern and contour fit that rifle.
• One-Piece Rail — A single rail runs the length of the base, which keeps the front and rear rings on one surface and in line with each other.
• Aluminum Construction — Aluminum is rigid enough to hold zero on a rimfire and keeps weight off a light .22 rifle.
• Cross-Slotted Top — Evenly spaced cross slots catch the recoil lug on each ring, the small bar under the ring clamp that stops it from sliding along the rail.
• Adjustable Ring Spacing — With slots along the full length, you can move the rings forward or back to set eye relief, the distance between your eye and the scope where you get a full picture.
• Weaver-Style Ring Compatible — The rail accepts Weaver-style scope rings and optic mounts.
• Four-Screw Attachment — Four countersunk screw holes sit flush with the rail and spread the clamping load along the receiver.
• Matte Black Finish — A low-glare black finish matches most rifle receivers and does not throw reflections.

Fit and Installation

This base is for the Remington 597 only, so check your rifle model before ordering. Once it is screwed down to the receiver, any Weaver-style rings in the right height and tube diameter for your optic will clamp onto the slotted top. Weaver has made scope bases for decades, and this one is part of its model-specific range.