Walther P99 Magazine

Factory P99 Magazine

This is Walther's own 15-round 9mm magazine for the P99 pistol. P99 owners use it as a spare for the range, a carry reload, or a replacement for a worn original. Because Walther makes it, it is built to the same dimensions as the magazine that shipped with your pistol, so you are not left guessing about fit the way you can be with an aftermarket copy.

Features

• 9mm Caliber — Marked CAL. 9MM on the body and made for 9x19mm, the standard 9mm Luger pistol cartridge.
• 15-Round Capacity — Holds 15 rounds, the standard full-size capacity for the P99.
• Steel Body — The magazine tube is steel in a black finish, with pressed ribs down the sides that add stiffness and help guide the cartridges.
• Witness Holes — Small holes along the rear spine let you see how far the magazine is loaded without emptying it.
• Polymer Base Plate — A black polymer floor plate closes the bottom of the magazine and sits close to the grip when seated.
• Polymer Follower — The follower, the platform that pushes each round up toward the chamber, is polymer rather than bare metal.
• Drop-Free Design — An empty magazine falls clear of the grip when you press the release, which speeds up reloads.
• Made In Italy — The body carries the Walther banner logo and a Made in Italy stamp.

Fit And Construction

The magazine fits the Walther P99 in 9mm. The cut-out on the rear spine engages the pistol's magazine catch, the latch that holds the magazine in place until you release it. The steel tube and polymer base plate are the same pairing Walther uses on its factory magazines, so the spare will handle and seat exactly like the one already in your pistol.